Let the machine cool completely before changing the cover.
Otherwise it may burn whoever is operating the machine.
Turn the power off before doing this operation.
Use a cover supplied by Sankosha.
Using another company’s cover may give a bad finish; Sankosha can take no responsibility
if this is done.
Cover/Pad Change Instruction
1.
How to change the Collar Cover/Pad
①
Push both start buttons without shirt on the machine.
(Figure-1)
②
Turn OFF the power supply after setting the air pressure
to 0 MPa. (
See page 15)
③
Remove the guard plate in front of middle press head.
(Figure-2)
④
Loosen equally two wing bolts which see from the
front and are in right-hand side.
Color cover loosens. Remove a stainless rod from a
hook and remove a color cover. (Figure-3)
There are 3 stainless rod in old cover,
remove them and install in the new cover.
Guard plate
Figure-1
Fixed screw
(3 Pcs.)
Color cover
Wing bolts
Stainless rod
Stainless rod
Figure-2
CAUTION
Figure-3
Caution
19
Summary of Contents for LP-660E-V2
