2.
In2 (Input test 2)
・
After 1.2 process, when
is displayed, push
④
Enter button.
・
When
⑤
Set/Select Dial is turned, input display number registered in software
(Table -1) is displayed by turns. The lamp of
③
Short button will be turned on if displayed
input sensor is in ON setting.
3.
out
（
output test
）
・
After 1,2 process, when
is displayed, push
④
Enter button.
・
Select display number of
（
table- 2
）
with
⑤
Set/Select Dial. When
④
Enter button is
pushed, test operation starts.
Table
－
2
Output test list
Display
number
Output name
Notes
2
Ａ
Close Middle Arm
Valve
①
2
ｂ
Close Upper Press Arm
Valve
②
2
ｃ
Close Upper Press
Valve
③
4.
VoL
（
Volume function setting
）
・
After 1, 2 process, when
is displayed, push
④
Enter button.
・
After display number (table3) is selected with
⑤
Set/Select Dial, when
④
Enter button is
pushed, present setting time is displayed. Setting time is changed with
⑤
Set/Select Dial and
push
④
Enter button to save it.
Table
－
3
Volume list
Display
number
Setting contents
Factory setting time
Ｖ １
Time from cuff press move to until down.
1.8sec.
（
Max.3.0 sec.
）
Ｖ ２
Time between collar press head rising and collar press arm,
cuff press arm rising.
0.0sec.
（
Max.1.0 sec.
）
Ｖ ３
Time between cuff press operation and starting of collar /cuff
mode.
1.0sec.
（
Max.10.0 sec.
）
Ｖ ４
Time between collar press head finishing and collar mode
starting.
1.0sec. (Max.10.0 sec.
）
Ｖ ５
Time between collar press head rising and cuff press rising.
0.5sec.
（
Max.1.0 sec.
）
An output test should stop air and steam.
There is possibility of machine failure or burn.
CAUTION
25
Summary of Contents for LP-660E-V2
