Check Item (Daily)
1.
Air Pressure
：
Figure-1
Please make sure if the air pressure gauge at the regulator is at the standard level. See “Main Devices”
and “Operation Procedure* Provide Air” in the Instruction Manual for the installation location and standard
pressure level.
［
How to Adjust Pressure
］
①
Pull the adjustment knob up
②
Turn the knob to adjust air pressure
・
Clockwise
→
Pressure will increase
・
Counterclockwise
→
Pressure will decrease
③
Pull the knob down
Regulator/Mist Separator
：
Figure-2
Check if the automatic drain function works properly at
the Regulator/Mist Separator. The drain is
automatically discharged when the quantity of the drain
reaches over half of the drain case.
If the drain cannot be discharged even after over half of
the drain case is filled, it might malfunction. Turn the
dial under the Regulator to the left and let the drain
discharge.
2.
Steam Pressure
：
Figure-3
Check the steam pressure gauges
（
0.6MPa
）
.
※
If the steam pressure does not reach the
required level, it may adversely affect the
shirt finishing quality.
Steam Pressure Gauge (0.6MPa
）
Adjustment
②
Adjustment
①
Adjustment
③
(Pressure increases)
(Pressure decreases)
Figure-1
Drain Outlet
Figure-2
Drain Discharge Level
Figure-3
33
Summary of Contents for LP-660E-V2
