3.
Steam Trap
：
Figure-4
Check to see if the Steam Trap works properly.
If not, it may malfunction. If the trap is our recommended
OVK’s trap, open the faucet and discharge the drain. Close
the faucet after discharge.
4.
Cover and Padding
：
Figure-5
Check to see if it is dirty, tear or not.
(Collar cover, Cuffs cover)
Dirt and tear can affect quality.
5.
Check and clean press surface
：
Figure-5
Clean the upper press and middle press surface
to remove dirty and detergent deposit. (After
stopping steam) Clean it when it is hot.
Clean is required to prevent the deposit from
burning and to keep ironing quality.
6.
Emergency Stop Button
：
Figure-5
Press the emergency stop button, right safety
bar and left safety bar to ensure that the
machine stops.
Start Operation
After checking the above items, start operation after warming up the machine sufficiently (for 15 to 20 minutes
after the steam is turned on).
Check Item (Annual)
7.
Regulator/Mist Separator Cleaning
:
Figure-6
Clean the filter of Regulator/Mist Separator. Change
the Filter Element if any pressure descent frequently
takes place.
Emergency stop button
Collar cover
Upper press surface
Middle press surface
Cuffs cover
（
2 places
）
Right safety bar
Filter Element
※
Steam Trap
OVK YH-15H
（
Recommended
）
Faucet
Figure-4
Left safety bar
Figure-5
Figure-6
34
Summary of Contents for LP-660E-V2
