3
Safety Guidelines
Warning labels are placed on the machine in order to prevent the operator and others from injury, and to ensure the
correct, safe operation of this machine. For the most part labels are placed on the operational parts of the machine.
Use this product safely upon reading this manual and understand the warning labels on the machine.
Please keep this manual, as it will be needed in the future.
■
Please find an explanation of the warning labels below. You will find the symbols used along with an explanation
of the degree of risk of injury or damage if the manual and or labels are not followed.
DANGER
This indicates a potentially hazardous situation which, if not
followed, could result in death.
WARNING
This indicates a potentially hazardous situation which, if not
followed, could result in serious injury.
CAUTION
This indicates a potentially hazardous situation which, if not
followed, may result in minor or moderate injury.
■
Regulations are shown in a table below.
Generality
This is used to note unspecified caution,
attention or danger.
General Prohibition
This is used to notify of unspecified
prohibition.
Shock Hazard
This is used to note the Possibility of electric
shock in certain circumstances.
Prohibition of Dismantling
This is used to note the possibility of injury
or shock if indicated parts are dismantled.
Cut Hazard
This is used to give notice of possibility of
wounding of hand and fingers by a cutter
and may cause physical handicap.
Attention
This is used to draw unspecified attention to
user actions.
Burn Hazard
This is used to note the possibility of burns
from live or contained steam.
Necessity to Ground
This is used to indicate that the machine
must be properly grounded, using the
attached green wire.
Pinch Hazard
This is used to note the possibility of
pinching by rollers which may cause
Permanent damage to extremities.
Rotation
Hazard
This is used to note the possibility of injury
if rotating parts of the machine are not
property covered during maintenance or
operation.
Rotation
Hazard
This is used to note the possibility of injury
if rotating parts of the machine are not
properly covered during maintenance or
operation.
Sankosha cannot be held legally responsible for any injuries to operators or damage to machines caused
by alterations to machines or operations not described in the machine manual.
Summary of Contents for LP-690E-V3
