18 / Opera
tor’s Manual Sanli GT26
5. Troubleshooting
Problem
Probable causes
Solution
The device does not start/
does not work
The « Start/Stop» switch is
in the
STOP
position
Put the start/stop switch
into the START position.
The air filter is dirty
Clean or replace the filter
The spark plug is dirty
and/or badly set
Clean it, set the electrodes
at 0.5 mm
The spark plug is old and
worn
Change the spark plug
There is no fue
l
Fill up the tank
The mixture is too old or of
bad quality
Drain the fuel tank, and fill it
up with fresh 2 stroke
mixture
The carburettor is
obstructed or badly set
Contact a SANLI approved
repairer or specialist
workshop
The exhaust pipe is blocked
Clean it to unblock it or
change it
The engine works but the
spool doesn’t move
The spool is blocked due to
the cutting debris
Stop the device, remove the
objects blocking the spool or
contact a SANLI-approved
repairer
The transmission is faulty or
worn
Contact a SANLI-approved
repairer to dismantle it.
The cutting line doesn’t
come out
The line spool is empty
Replace the wire spool or
contact a SANLI-approved
repairer
The automatic nylon line
feeding system is dirty
Dismantle and clean the line
and its support or contact a
SANLI-approved repairer
Summary of Contents for GT 26
Page 1: ...PLEASE KEEP THIS MANUAL IN A SAFE PLACE Petrol Trimmer www sanli co uk...
Page 25: ...Operator s Manual Sanli GT26 25 Engine powered generators...
Page 26: ...26 Operator s Manual Sanli GT26 Notes...
Page 27: ...SANLI UK LTD Unit 200 Milton Park Estate Abingdon Oxfordshire OX14 4TB www sanli co uk...