8
Sanli Blower / Blower Vac User Guide
Mix 25 parts of 95 octane regular
unleaded petrol to 1 part 2-stroke oil
(25:1). Do not overfill the tank as this can
risk fuel spilling on hot parts when in use.
Press primer bulb three or four times until
a flow of fuel is visible inside the fuel line
see (
Figure 6)
.
Slide the ignition switch back from the
STOP position (
Figure 7)
.
Set choke lever into closed position if
starting from cold
(Figure 8).
Pull the starter cord until the Blower /
Blower Vac starts (or sounds like it wants
to start) then return choke to open
position
.
After it starts, allow the engine to warm up
for at least 20 to 30 seconds.
For warm restarts, do not prime, just pull
the cord and it will start after one or more
pulls.
To stop the engine, simply slide the
ignition switch forward to the
STOP
position
(Figure 9).
Figure 7.
Figure 8.
Figure 9.
Figure 6.
Starting your Blower /
Blower Vac.
STOP
ON
