SANLI Victory BIG350, Instruction Manual

PAGE 6

INSTRUCTION MANUAL

BEFORE YOU BEGIN

WARNING!

   The following procedures must be carried out before you start the engine of your lawnmower.

FILL OIL SUMP WITH 600ml of 
SAE 30 Oil

FILL FUEL TANK WITH 
PREMIUM PETROL (NO E10 
PETROL)

!

MAX MIN

Filling oil sump with oil

You have to add 600ml oil before 
starting the engine for the  rst 
time.

1.

Firstly, remove the warning 
label from under the dipstick, 
then remove the dipstick and 
slowly pour 600ml of SAE30 
engine oil into the engine via 
the oil  ller (Fig. 1). Replace the 
dipstick and tighten.

2. 

 Before you use the mower each 

 time, check the oil level (Fig. 2) and
if necessary top up with SAE30 
engine oil. To check the oil level,
unscrew the yellow dipstick, wipe 
with a rag and dip into the oil  ller 
(do not screw back in place), 
remove the dipstick again and 
check the level. 

3.

The oil level must be between 
the min and max marks  on the 
dipstick (Fig. 3). Replace the 
dipstick and screw into place.

Fill Fuel tank with min 95 octane 
premium unleaded petrol (Do not 
use Ethanol petrol ie. E10).

Petrol is highly  ammable so 
extreme caution must be taken 
when handling it. Always store 
petrol in approved containers and 
you must ensure that you use fresh 
petrol that is less than 4-6 weeks 
old. Do not mix oil with petrol. 

4.

To put petrol in the fuel tank,

rstly remove the warning label 

from under the petrol cap. 

It’s best to  ll the tank using 
a clean funnel, but never  ll it 
completely (Fig. 4). Instead, 
leave at least 13mm from 
the bottom of the  ller neck to 
allow for expansion. Ensure that 
you securely tighten the petrol 
cap after  lling. 

(Funnel & Fuel 

not supplied).

Fig 1

Fig 2

Fig 4

Fig 3