Page 10
2.4.3 Beep feature
This is a people warning feature for transports in public areas.
How to activate the Beep feature: Turn on the device and hold down the On-/Off-
/Ascend-/Descend
– button (P) for about 30 seconds until you can hear a beep signal.
Now the recurring beep signal is available while you are driving with the SAL.
How to disable the Beep feature: Turn on the device and hold down the On-/Off-
/Ascend-/Descend
– button (P) for about 30 seconds until you can hear a beep signal.
Afterwards you can drive without the recurring beep signal.
2.4.4 Speed switch
Use the speed switch to select either high or low speed
– this can only be used in
ascent mode. (In descent mode the descending speed is permanently set so that
optimum braking will always be secured
– refer also chapter Operation
[
4.2])
Low speed is advisable for: training, heavy loads and in awkward locations.
2.5 Ascend button in upper handle
This button [Q] is only active in the ascent mode and switches the lifting mechanism
on and off.
Summary of Contents for Liftkar SAL Uni
Page 2: ...Page 2...
Page 6: ...Page 6 2 Controls 2 1 Model ERGO...
Page 8: ...Page 8 2 3 Model UNI...
