JCD3007
3
10. Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit.
Removing the Unit
Dashboard
Removal Key
To remove the radio after installation:
1.
Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a
groove downwards and re-attach.)
2.
Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not
lock properly to release the unit.
Trim Plate Installation
Push the trim plate against the chassis until it is fitted.
You must do this before you install the control panel, otherwise it can't be
attached.
DIN Rear Mount (Method B)
This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to
mount the radio to the dashboard. Please consult with your local mobile stereo shop for assistance on this type of installation.
1.
Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used
to mount the new radio.
2.
Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove and discard the trim ring.
Screws
Factory Mounting Bracket
Hook (Remove)
Dashboard
3.
Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select a position where
the screw holes of the bracket and the screw holes of the main unit are aligned (are fitted). Tighten the screws at 2 places on each side.
Do not exceed M5 x 9 MM maximum screw size. Longer screws may damage components inside the chassis.
4.
Wire the new radio to the vehicle as outlined in the Universal Installation instructions.
5.
Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1.
NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
WIRING
FUSE
20-PIN AUDIO/POWER HARNESS (See Figure 1)
REAR LINE OUT
RCA-TO-RCA CABLE (not supplied)
ANTENNA JACK
ANTENNA EXTENDER CABLE
Figure1: 20 PIN HARNESS PIN CHART
PIN NO.
WIRE COLOR
FUNCTION/LABEL
GRAY/BLACK
RIGHT FRONT SPEAKER (-)
GRAY
RIGHT FRONT SPEAKER (+)
VIOLET
RIGHT REAR SPEAKER (+)
VIOLET/BLACK
RIGHT REAR SPEAKER (-)
EMPTY
NO CONNECTION
GREEN
LEFT REAR SPEAKER (+)
GREEN/BLACK
LEFT REAR SPEAKER (-)
