JCD3007
5
•
error symbol on the display
Reset Back Up Memory
The u
nit supports last operation memory. To resume the last operation, press “MODE+M1” together.
Audio Menu
Press the
AUDIO
button (4) on the control panel to access the Audio Menu. You can navigate through the Audio Menu items by pressing the
volume control button repeatedly. Once the desired menu item appears on the display, adjust that option by turning the volume control knob
within 5 seconds. The unit will automatically exit the Audio Menu after five seconds of inactivity. The following menu items can be adjusted.
Volume Level
Use the button to adjust the Volume level from “00” (lowest) to “100” (highest).
Bass Level
Use the button to adjust the Bass level range from “-10” to “+10”.
Treble Level
Use the button to adjust the Treble level range from “-10” to “+10”.
Balance
Use the button to adjust the Balance between the right and left speakers from “10L” (full left) to “10R” (full right). “BAL L=R” represents an
equal balance between the right and left speakers.
Fader
Use the button to adjust the Fader
between the rear and front speakers from “10R” (full rear) to “10F” (full front). “FAD R=F” represents an
equal balance between the front and rear speakers.
VOLUME /\
fades to rear and
VOLUME \/
fades to front.
TUNER OPERATION
Select a Band
Press the
BAND
button
(21) on the control panel to change between three FM bands and one AM band. Each band stores up to six preset
stations.
Tuning
Auto Seek Tuning
Press the
TUNE
up (19) or
TUNE
down button (18) on the control panel for less than three seconds to move to the next station automatically.
Manual Tuning
Press the
TUNE
up (19) or
TUNE
down button (18) for more than three seconds to enter manual tuning mode. Press the
TUNE
up or
TUNE
down button to change the radio frequency number up or down one step. The radio signal strength meter indicates the strength of the current
radio station broadcast.
Best Reception
Weak Reception
Scan
Press the
SCAN
button (22) to automatically search for stations. Each available station will flash on the display for a few seconds before the
next is searched. To select a “flashing” station, press the
SCAN
button again.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (9-14) for three seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (9-14) to select the corresponding stored station.
Automatically Store / Preset Scan (AS/PS, AMS)
Automatically Store
Select a band (if needed). Press
AS/PS
(16) on the control panel for more than three seconds to automatically select six strong stations and
store them in the current band. The new stations replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press
AS/PS
(16) to scan stations stored in the current band. The unit will pause for ten seconds at each preset
station. Press
AS/PS
again to stop scanning when the desired station is reached.
