58
6.01 Stick Welding
•
Connect work lead to negative terminal.
•
Connect electrode lead to positive terminal.
•
Switch machine on.
•
Wait for machine to cycle thru the start-up sequence during which the software version,
followed by the machine code is displayed on the front Panels Digital Display.
•
Set
AC
or
DC
weld current. If
AC
is selected then set
AC FREQ
to 60Hz &
WAVE BALANCE
to 50%.
•
Disable the
WATER COOLING
function of the welding power source in STICK mode.
•
Set Contactor.
•
Connect remote control device if required.
Use the Scroll Buttons to move to the parameter to be set. An illuminated LED indicates which
function is being adjusted on the weld sequence graph. Use the control knob to adjust each
parameter.
•
Set
HOT START
.
•
Set
WELD
current.
Commence welding.
Summary of Contents for IA-3000TP-U3E
