|
info
@
sansdigital.com
|
phone 800 980 1988
|
fax 626 322 3878
Setup RAID level
1.
There are 8 different RAID setting to choose from. To create different RAID level, please change the
RAID switch to desire setting.
Normal / JBOD
RAID 0
RAID 1
RAID 3
RAID 5
RAID 10
Large / Spanning
Clone
2.
Hold reset button for 5 seconds. The RAID mode will reset according to the dip switch setting.
NOTE: DATA IN YOUR HARD DRIVE WILL BE ERASE WHEN YOU HOLD RESET
BUTTON
3.
Go to Disk Management (Windows), Disk Utility (Mac) or partition managers utilities (Linux) for
partition and format.
4.
Reboot the computer if newly created RAID does not detected
Notes
After RAID creation, you will need to partition and format the drives. Please follow your OS
instructions for partition and format.
Data will be lost when you setup the RAID level, partition or format.
