6
How to attach the stand
NOTE:
• Unplug the AC cord from the AC outlet.
• Ensure that unpacking and transfer of the unit is carried out by two or more people.
• Before beginning this process, assure that the TV is laid on a clean, safe, and cushioned surface to avoid
any damage to the unit.
• Do not touch or press the TV-screen, glass might break under pressure.
Place the TV on its front onto a table.
Align the stand’s bottom-plate (supplied) as seen here.
It will
fi
t in only one direction.
Hold the unit and attach the stand slowly, as shown in Figure 1.
How to remove the stand
When you transport this product, remove the stand and pack
fl
at against the back of the unit in the carton. To
remove the stand, perform these steps in reverse order.
For wall mounting, the base must be removed. To disconnect the base/stand remove the 4 screws from the back
(see page 5).
Finally secure the bottom-plate with 4 screws (supplied) as indicated by the arrows in Figure 2.
Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support
your unit correctly, and could result in damage or injury from tip-over.
•
LCD PANEL SIDE
Figure 1
Figure 2
Illustration is SLED4280
3CQ0821B_En.indd 6
3CQ0821B_En.indd 6
10/7/10 4:37:07 PM
10/7/10 4:37:07 PM
Summary of Contents for SLED4280
Page 27: ...Memo...
