Page | 33
© Sansui UK 2012 WLD+201 IB Ver 1.0 Rev 0.0
high dynamic range in a noisy environment (for
example, classical music while cooking).
To change the DRC of the WLD+201, select
Menu > DRC
, and then
DRC high
,
DRC low
or
DRC off
.
Note:
The WLD+201’s DRC setting does have any
effect if DRC data is not included in the broadcast.
Station order
You can choose the order of the DAB station list to be
either
Alphanumeric
,
Ensemble
or
Valid
.
Ensemble
lists
groups of stations that are broadcast together on the
same ensemble, for example
BBC
or
South Wales
local
.
Valid
lists valid stations first, alphanumerically,
then off-air stations.
To change station order, select
Menu >
Station order >
then
Alphanumeric
,
Ensemble
or
Valid
.
13.
FM radio mode
FM radio mode receives analogue radio from the FM
band and displays RDS (Radio Data System)
information about the station and show (where
broadcast).
To enter FM mode, either press Mode until the display
shows
FM Radio
or select
Menu >
Main menu > FM
.
Selecting stations
To find a station, press Select . The frequency display
starts to run up as the WLD+201 scans the FM band.
Alternatively, you can scan up or down by pressing
and holding the
and
buttons or tune manually
with quick presses, or by turning the Select control.
Presets
To store an FM preset, press and hold P on the remote
handset until the display shows the
Save preset
screen. Select one of the 10 presets to save the
currently playing station. Press Enter on the remote to
store.
To select a preset, press P on the remote control
handset briefly, then select one of the listed preset
stations with the up or down arrow keys. When a
preset station is playing, it shows P
n
(P1, P2 etc) in the
bottom right of the screen.
Now playing information
While an FM station is playing, the screen shows one of
the two following sets data:
-
If RDS information is available, by default
the service name (i.e. station name) is
displayed. You can cycle through further
RDS information by pressing
Info
Each time you press
Info
, another set of
information is displayed, cycling through
RDS radio text, RDS program type,
frequency and today’s date.
-
If no RDS information is available, the
currently tuned frequency is shown.
Settings
Scan settings
By default, FM scans stop at any available station. This
may result in a poor signal-to-noise ratio (hiss) from
weak stations. To change the scan settings to stop
only at stations with good signal strength, select
Menu
>
Scan setting > Strong stations only?
>
Yes
.
