INSTALLING THE OPTIONAL REMOTE HUMIDITY CONTROL
CAUTION!
THIS SHOULD ONLY BE PERFORMED BY A
QUALIFIED ELECTRICIAN.
A 110-120 VAC remote humidity control is available from the
factory. This replaces the factory mounted humidity control on
the cabinet of the dehumidifier, and allows the unit to accurately
sense the humidity in an area other than the one where the unit is
located.
1. Unplug the unit.
2. Pull the black humidity control knob off from the side of the
unit, exposing 2 screws. Remove the screws.
3. Remove the front panel of the dehumidifier by removing 6
screws.
4. Remove the 4 screws securing the wiring box to the inside of
the blower end of the dehumidifier, and pull the box away from
the cabinet to allow access.
5. Insert a romex connector or conduit connector into the hole in
the cabinet that is left after the dehumidistat is removed. Pass
the cable to be used to connect to the remote dehumidistat
through the connector.
6. Disconnect the dehumidistat leads and reconnect with the new
wires.
7. Replace the wiring box and screws. Replace the front cover
and screws. Tighten any loose screws on the connector.
8. Run the new wire to the location desired to sense relative
humidity. Install a 110-120 VAC dehumidistat according to local
electrical codes.
9
Santa Fe Classic Installer’s & Owner’s Manual
SANTA FE CLASSIC ACCESSORIES LIST
•
To order contact your reseller or call 1-800-533-7533
ITEM
PART NO.
DESCRIPTION
1 4021468 Pre-Filter
2
4028522
MERV 11 Pre-Filters 12-Pack
3
4021475
MERV 11 Filter (16"x20"x2")
4
4027417
MERV 11 Filters 4-Pack + 1 Pre-Filter
5
4027424
MERV 11 Filters 12-Pack
6
4024528
Bulk Carbon Granules
7
4022220
Pump Kit
8
4022561
Muffler Kit
9
4021453
Duct Kit (includes 8" supply collar)
10
4020656
6" Inlet/Exhaust Hood
11
4026859
6" Flex Duct 25'
12
4020128
6" Flex Insulated Duct 25'
13
4020623
8" Supply Collar
14
4027415
8" Flex Duct 25'
15
4020177
8" Flex Insulated Duct 25'
16
4020175
Remote Dehumidistat
8.
