INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the hook post
out
of the box.
Place the post against the assigned wall location.
Make sure that the hook
is
leveled.
Mark the post flange position and remove the trim.
2-
Using the Allen key provided, remove the mounting screw
bracket
from
the
hook post.
Press the mounting screw
bracket
against marked hook post position on
the
wall and mark the screw hole positions.
2a-
INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting screw
bracket
can be secured
by
screwing the screws directly into the wall.
2b-
INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the anchors.
- Insert the anchors into the wall.
- The mounting screw
bracket
can be secured by screwing the
screws
into the anchors.
2c-
IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting screw
bracket
by screwing the screws
into
the wall.
3-
Press the hook post against the mounting screw
bracket
.
Align the hook post and secure it by tightening the set screw.
4-
Check the hook post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
07/04
WALL
3966CI
_ _
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
post flange mark
mounting screw
bracket
