User manual
SanStore-4LEMX / SanStore-8LEMX / SanStore-16LEMX
SanStore-4LMX / SanStore-8LMX / SanStore-16LMX
_____________________________________________________________________________
- 44 -
Tune:
PTZ setup:
PTZ device are connected to the RS-422/485 ports located on the back of the unit.
Multiple PTZ cameras are connected by daisy-chaining the camera connection.
This DVR allows you to address and control multiple PTZ cameras individually.
Press [ENTER] to configure the PTZ setup. The menus are displayed with options on the
left-hand column and settings in the right hand column.
a. ID:
Configure the appropriate model and then enter the corresponding Baud rate and
camera PTZ ID (address).
b. Tour group:
Preset tours allow a camera to move though a programmed sequence of PTZ
presets.
Note:
The programmed tours are saved in the DVR and not in the PTZ camera.
The presets used for a tour are copied onto the PTZ camera, i.e. presets are
stored in the camera.
ITEM
DEFAULT
ADJUSTMENT
BRIGHTNESS
50
The brightness of each camera can be adjusted by pressing the
[-,+] buttons. Alternatively, use the mouse.
CONTRAST
50
The contrast of each camera can be adjusted by pressing the
[-,+] buttons. Alternatively, use the mouse.
COLOUR
50
The colour of each camera can be adjusted by pressing the [-,+]
buttons. Alternatively, use the mouse.
SATURATION
50
The saturation of each camera can be adjusted by pressing the
[-,+] buttons. Alternatively, use the mouse.