User manual
SanStore-4LEMX / SanStore-8LEMX / SanStore-16LEMX
SanStore-4LMX / SanStore-8LMX / SanStore-16LMX
_____________________________________________________________________________
- 7 -
1.3 Important general note
Please read the following instructions carefully.
1.3.1 Assembly and installation
On-site installation should only be performed by qualified maintenance personnel
and must meet local specifications and regulations.
Never operate the equipment without the respective protective cover near water, in
dusty rooms or extremely humid rooms. The equipment could be seriously
damaged.
The openings on the equipment are intended for ventilation purposes and protect
from overheating. Never cover or close off these openings. Rack mounting is only
permissible if sufficient ventilation can be ensured. Overheating may damage the
equipment or result in fire due to short-circuit.
Power cables and other cables should be run so as to avoid being stepped on or
potential damage from falling objects. Damaged cables may result in short-circuit
and equipment damage as well as potentially fatal electrical shock.
When connecting the supply voltage please note correct polarity. Faulty connections
may damage or destroy the equipment.
Only use the power source specified on the nameplate. Please consult your
electrician if you are unsure whether the power supply on site is appropriate. Only
use the supplied power cables or power adapters or the specified recommended
power supplies.
1.3.2 Maintenance and repair
Shut off and unplug the equipment from the power receptacle prior to every
cleaning. Only clean the equipment with a slightly dampened cloth. Do not use
harsh cleaners or spray cans. Using harsh solvents such as thinner or petrol may
damage the housing surface.
Immediately shut off the equipment and promptly disconnect it from the operating
voltage. The following damages must be handled by an authorized service centre:
o
Damage to the power supply cable
o
If a liquid spilled onto the equipment or an object penetrated the
equipment
o
If the equipment was exposed to water or another liquid
o
If the equipment is not functioning properly despite observing the
instructions in these operating instructions. Only the controls specified in
these operating instructions may be adjusted. Incorrect settings to the
other controls may damage the equipment.
o
If the equipment fell to the floor or the housing was damaged
o
If the equipment performance is substantially the required performance
Never attempt to maintain the equipment yourself, as this may expose you to
hazardous voltages. Maintenance work should always be performed by qualified
personnel only.
