User manual
/ VDC-610ID
_________________________________________________________________________________
- Seite 10 -
When Power on, DIAGONOSTIC is operated.
The following messages are displayed on the monitor.
A.
Pan Origin Test
Zero point of Pan is founded after Panning test.
B.
Tilt
Origin Test
Zero point of Tilt is founded after Tilting test.
C
.
TX connection Test
Countdown from 60 seconds for TX Connection Test,
during 60 seconds, the camera must receive a signal from any keys of controller or DVR s.
When received the correct signal, OK is displayed after TX CONNECTION TEST.
* If
“
No Tested
”
is di
splayed on the monitor,
- Camera did not receive the any signal.
- Camera did receive the signal but not correct it.
- User should check protocol, baud rate and RS-485 connection.
D.
Camera Comm. Test
Communication test with the camera is automatically checked.
OK should be displayed in these four tests before installation.
If all the above Tests are OK,
“
NOW EEPROM CHECKING
”
and
“
EEPROM OK
”
is displayed and the camera is
DIAGNOSTIC
CAMERA ID : 001
BAUD RATE : 2400 BPS
WAITING
………
PAN ORIGIN
CHECK OK
TILT ORIGIN
CHECK OK
TX CONNECTION
TEST OK
CAMERA COMM
TEST OK
