Santon Aquaheat AH30V, Installation And User Instructions Manual

5

3.1 LOCATION
3.1.1  The Aquaheat must be installed by a competent installer in accordance with 

Building Regulation G3.

3.1.2   National Wiring rules may contain restrictions concerning the installation of 

these units in bathrooms.

3.1.3   The unit should be vertically wall mounted using the wall bracket and levelling 

feet supplied. The water connections must always be on the bottom of the unit.

3.1.4   Enough space should be left below the unit for pipe connections and above the 

unit  for access to the Temperature/Pressure Relief Valve. Refer to Figure 2 and 

the Dimensions Table to determine a suitable position for the heater.

3.1.5   NOTE: Ensure that the wall can support the full weight of the unit               

(see TECHNICAL SPECIFICATIONS) and that there are no hidden services 

(electricity, gas, or water) below the surface of the wall.

3.1.6   DO NOT install where the unit may freeze.
3.1.7  Using Figure 01 and the Dimensions Table as a guide mark the position of the 

wall mounting bracket and lower location point. Drill and plug the wall with 

suitable fixings, fix the wall bracket to the wall.

3.1.8  Fit the heater wall bracket to the rear of the unit using the screws provided, 

ensuring the central location bolt is pointing towards the bottom of the unit.

3.1.9  Remove the backing paper from the self adhesive pads of the Levelling Feet 

and affix them to the lower back of the unit in the approximate positions shown 

in Figure 02.

3.1.10  Hang the unit on the wall mounting bracket ensuring the location bolt locates 

in the hole in the wall bracket. Position the moulded spacer block between the 

tab on the bottom cover moulding and the wall. Insert a No. 10 x 2 ½” long 

screw through the tab and spacer block and tighten into wall plug.

 3.0 INSTALLATION