SANTOS : User and maintenance manual
FAULT FINDING
Identify the exact reason the appliance stopped.
In every case:
If the problem persists, switch off the power supply to the machine
(unplug the cord from the mains socket) and call in the maintenance service or
contact a SANTOS approved dealer.
The machine will not start:
•
Check: the mains power supply and the condition of the power supply cord,
•
Note: the switch should be lit when on the "1" position.
•
Check that there are no foreign bodies stuck between the grinding wheels.
The machine stops because the motor has overheated:
(the metal casing around the motor unit is hot)
Models110-120V 50/60Hz only
In the event of overheating, the motor stops.
The overheating protection system resets automatically; wait for the motor to cool (15 to
30 minutes), before restarting the machine.
The machine stops because of an overload:
If the motor is blocked (foreign body, something too hard), the excess current protection
system
(14)
, located under the appliance will be triggered automatically and cut off the
electrical power to the motor.
•
Set the On / Off switch
(13)
to
"0"
position, disconnect the appliance.
•
Correct the fault then press the excess current protection button
(14)
•
Press the On/Off switch
(13)
(position I).
If the problem persists, check the following points:
•
Check that the grinding wheels do not touch each other.
•
Check the state of wear of the grinding wheels (grinding too fine with worn grinding
wheels can result in a motor overload like this)
•
If there are no foreign bodies preventing the appliance from working, then check
and replace the motor starter relay then the capacitor.
98101 US 3.0 - 09 2007
9
/ 20
www.santos.fr
