SANUPS A11H, Instruction Manual

Safety Precautions 

5

6. Radio Frequency Interference 

CAUTION

• 

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference when the equipment is operated in a commercial environment. This equipment generates, uses, 
and can radiate radio frequency energy and if not installed and used in accordance with the instruction 
manual, may cause harmful interference to radio communications. Operation of this equipment in the 
residential area is likely to cause harmful interference in which case the user will be required to correct the 
interference at his own expense. 

7. Battery Handling Precautions 

CAUTION

• 

Battery servicing should be performed by technically qualified personnel. Keep unqualified personnel away 

from batteries. 

• 

Replace batteries only with the same model and brand: HRL1234WF2FR manufactured by CSB BATTERY Co., 

LTD. Risk of explosion if battery is replaced by an incorrect type. 

• 

The batteries in this product are lead type batteries which are a reusable resource. Please cooperate by 

recycling when replacing or disposing of used batteries. Dispose of used batteries according to the instructions. 

Customers should not dispose of used batteries themselves. To dispose of used batteries, contact your nearest 

sales representative, an authorized industrial waste handling company, or repack them in their original cartons 

and send them to your supplier or SANYO DENKI.   

• 

Do not use batteries after their service life has expired. Doing so may result in fuming or fire. Additionally, the 

battery backup function may fail to operate with such batteries, so that power will not supplied to the load 

when a power outage occurs. 

• 

Batteries pose hazards for electrical shock and dangerous short-circuit current. The following precautions 

should be observed when working with batteries. 

a.  Remove watches, rings and other metal objects. 

b.  Use insulated tools. 

c.  Wear rubber gloves and boots. 

d.  Do not lay tools or metal parts on top of batteries. 

e.  Disconnect the charging source prior to connecting or disconnecting battery terminals. 

f.  Determine whether the batteries have been inadvertently grounded, and if so, remove the source of 

grounding. Contact with any part of a grounded battery can result in electric shock. 

• 

Do not attempt to open or disassemble batteries. The electrolyte is harmful to the skin and eyes. The battery 

contains diluted sulfuric acid, which is extremely toxic. If a battery leaks, take appropriate measures to prevent 

any battery fluid contacting your skin or clothing. Diluted sulfuric acid may cause blindness if it gets into the 

eye, may burn skin upon contact. It is electrically conductive and corrosive. Observe the following procedures if 

electrolyte spills: 

a.  Wear full eye protection and protective clothing. 

b.  If sulfuric acid contacts the skin, wash it off immediately with water. 

c.  If sulfuric acid contacts the eyes, flush thoroughly and immediately with water, and seek medical 

attention. 

d.  Spilled sulfuric acid should be washed down with a suitable acid-neutralizing agent, such as a solution 

of approximately one pound (500 grams) bicarbonate of soda in one gallon (4 liters) of water. The 

bicarbonate of soda solution should be applied until evidence of reaction (foaming) has ceased. The 

resulting liquid should be flushed with water and the area dried.   

• 

Lead acid batteries can present a risk of fire due to generation of hydrogen gas. The following procedures 

should always be followed: 

a.  DO NOT SMOKE when near batteries. 

b.  DO NOT allow flames or sparks near batteries. 

c.  Before working with batteries, discharge static electricity from the body by first touching a grounded 

metal surface before touching the batteries. 

• 

If a fire occurs near a battery, do not use water to extinguish it. Use only a powder-distinguishing agent (ABC). 

Using water can cause the fire to spread.   

• 

Do not dispose of batteries in fire, as they could explode. 

• 

Strictly observe the following precautions when handling the batteries. Failure to do so may cause battery 

leakage, overheating or explosion. 

a.  Do not solder to any part of the battery directly. 

b.  Do not charge the battery with reversed positive (+) and negative (-) terminal polarity. 

c.  Do not mix different battery types, brands or versions. 

d.  Do not attempt to peel off or break the outer covering of a battery. 

e.  Do not subject batteries to strong physical shock, or throw them away. 

f.  Clean batteries with water-moistened cloth squeezed hard. Do not use organic compounds such as 

gasoline, thinner, benzene or detergent. 

g.  Electrical energy may remain in a battery even after its service life has expired.   

Do not allow sparks near used batteries, and protect them from short-circuiting. 

！

！

！