●
Studs must be at least 2x4 in. / 25 ga.
●
If back side of wall is unfinished, drywall must be installed to a minimum of one stud left and right of the stud(s) being used to install the mount
●
Drywall must be a minimum of 1/2 in. (13 mm) thick on each side of the studs, and a minimum clearance of 1 ⅞ in. (48 mm) behind the wall is required
●
Pilot holes MUST be drilled to a depth of 1 in. (26 mm), using a 1/2 in. (13 mm.) diameter drill bit
●
This product must be centered on the studs
●
Stud type and structural strength must conform to the North American Specification for the Design of Cold-Formed Steel Structural
Members [362 S 125 18, C-Shape, S - Stud Section]
●
Drywall must be secured to studs with screws 12 in. (304.8 mm) on center
Steel Stud Anchor Kit #SSMK1 is not included
-
Contact Customer Service to inquire about obtaining additional hardware.
CAUTION:
Avoid potential personal injury or property damage!
14
1/4-20 x 1¾ in.
1/4 in.
1/4-20 Snap Toggle BB
STEP 2C Attach Wall Plate
Steel Stud Installation
S1
x4
S2
x4
S3
x4
