13
17
3
4
3. Drill pilot holes then remove the wall plate template
15
.
IMPORTANT
: Be sure to drill into the center of the stud.
IMPORTANT
: Pilot holes must be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
4. Install the wall plate
16
using four lag bolts
17
and washers
19
. Tighten all lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt.
DO NOT over-tighten the lag bolts
.
Go to PAGE 16.
16
19
15
75 mm (3 in.)
5.5 mm
(7/32 in.)
