6901-002131 <00>
6
3
Wall Mounting - Wood Stud
3 mm
(1/8 in.)
3-1
Locate stud
3-2
Level wall plate [01] and mark hole locations
3-3
Drill pilot holes as illustrated
3-4
Tighten lag bolts [03] only until they are pulled fi rmly against the wall plate [01]
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage:
DO NOT
over-tighten the lag bolts
[03]
.
< 16 mm
(5/8 in.)
63.5 mm
(2.5 in.)
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage: pilot holes
MUST
be drilled to a depth of 63.5 mm (2.5 in.), using a 3 mm (1/8
in.) diameter drill bit.
[01]
[01]
[03]
Summary of Contents for VMFL1
Page 9: ...6901 002131 00 9 ...
