SANUSLIFE ECAIA S, Operating Instructions Manual

11

If you wish to use the ECAIA ionizer S+ again without the ECAIA ionizer S faucet, you can 
reprogram the ECAIA ionizer S controls as described below:

1.  On the ECAIA ionizer S faucet, press and hold the “Power (D-D1)” and “Alkaline lev-

els (ALK) (D-D2)” buttons at the same time until “F-1” appears on the display. 
 
 
 
 
 
 

4.4 

Reprogramming the ECAIA ionizer S+ control to ECAIA ionizer S

2.  On the ECAIA ionizer S faucet, press and hold the “Acidic levels (ACID) (D-D3)” but-

ton until “F-0” appears on the display. 
 
 
 
 
 
 
  

3.  On the ECAIA ionizer S faucet, press and hold the “Power (D-D1)” and “Alkaline lev-

els (ALK) (D-D2)” buttons at the same time until the display switches off. This saves 
the setting. 
 
 
 
 
 

4.  Unplug the power cable of the ECAIA ionizer S+ from the socket so that the device 

is no longer connected to the electricity supply. 
 
 
 
 
 
 
 
 

5.  Carefully disconnect the control cable (D-A) from the connector under the connec-

tion cover on the back of the ECAIA ionizer S+.  
 

Warning

: Do not pull on the individual cables at the 

plug of the control cable (D-A) as this may damage 
the cable!