SANUSLIFE ECAIA S, Operating Instructions Manual

7

quick-release fastener opening of the water inlet (B-11) on the bottom of the ECAIA ionizer S. 
Finally, fix the 5 1/4” safety pins (C-6) in place. Afterwards, connect the cable of the solenoid 
valve (C-12) to the cable plug-in connector on the bottom of the ECAIA ionizer S. 
 

4.  The water pressure can be adjusted with the adjustment screw on the T-piece (A-10). 

Note

: If there is not enough water pressure, remove the water pressure reducing valve (C-

13) if necessary. If the flow becomes slower after a while, the filter (A-7) and/or the water 
pressure reducing valve (C-13) may be dirty and may need to be cleaned or replaced.

4.2 

Installation of the additional ECAIA ionizer S faucet

 Compare table F (page 3).

In order to avoid damaging the fixtures and fittings, the hoses should be connect-

ed by a professional.

1.  Connect the 5/16" outlet hose for al-

kaline water (C-8) to the 5/16" quick 
release fastener (D-B) on the fitting 
and secure the 5/16" safety pin (C-6). 
 

2.  Connect the 1/4" outlet hose 

for acidic water (C-8) to the 1/4" 
quick-release fastener on the fitting 
and secure the 1/4" safety pin (C-6). 

5/16"

5/16"

1/4"

1/4"