8
Instruction Manual for HRV
1-888-726-8869
www.sanuvox.com
How to Clean your Product
For optimal performance, the lamp should be kept free of dust and residue deposit. Clean when necessary with mild soap or
alcohol. Always spot test the cleaner to make sure it does not damage the surface.
CAUTION: Under no circumstance should water be sprayed or splashed onto the product.
ULTRAVIOLETS: UVC
The UVC (254 nm) wavelengths produced by Sanuvox UV units and systems are the same as the ultraviolets produced by the
Sun. The UVC attacks the micro-organisms on a molecular level deactivating the contaminants. Unlike conventional UV lamps
on the market, Sanuvox UV units and systems use a patented process designed to deliver the maximum UV dosage to the
moving airstream or surface.
CAUTION: Never expose eyes or skin to an operating UV lamp.
STORAGE
The HRV is an permanent in-duct unit working continuously when powered and therefore, requires no specific storage.
ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE
The product is rated at 120 / 277 / 240 VAC, 50/60 Hz. The HRV6 has a power of 25 Watts, and th HRV8 of 40 Watts.
See product label to confirm power consumption of your specific unit or system.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CUSTOMER SERVICE FIRST OR SEE YOUR WARRANTY.
DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE
PRODUCT OR TAMPER WITH ITS COMPONENTS WITHOUT CONTACTING CUSTOMER SERVICE FIRST. DOING SO
MAY VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.
TROUBLESHOOTING
If your product is not working properly, refer to the following.
What you will need
A flat head screwdriver and an ohmmeter.
Problem
Possible Cause
Solution
Both LEDs are OFF / not lighting up.
- The electrical outlet is not powered.
- Defective unit.
- Test the outlet to make sure there is
power by plugging in another electrical
appliance.
- Contact your contractor.
The red LED is OFF.
- Defective ballast.
- Contact your contractor.
The amber LED is OFF.
- Defective lamp.
- The UV lamp has exceeded its lifespan.
- Check lamp continuity.
See UV Lamp Continuity Test
instructions on page 9 (A).
- Get a genuine replacement lamp and
replace your lamp.
Contact your contractor for all your needs in terms of replacement parts: ballast, UV lamp, etc.
