6
Instruction Manual for SABER MAGNET 24V
1-888-726-8869
www.sanuvox.com
OPERATION
How to Operate your Product
The SABER MAGNET 24V is an automatic unit: once it’s installed and plugged in, it immediatly turns ON on its own.
CAUTION:
The suggested operating temperature range is 10 to 50°C (50 to 122°F). Operating the SABER MAGNET 24V
outside this range will result in decreased performance.
How to Read the Ballast Display
Once the power has been reconnected the ballast LED will illuminate as will the UV Lamp. In the event the LED status light is
OFF this signals that there is either no power going to the ballast or the ballast has failed. When the LED flashes it is time to
replace the UV Lamp (after 1 year of use). Once the UV Lamp has been replaced hold the RESET button for 3 seconds to reset
the ballast timer.
Normal Operation
SOLID RED:
In operation, system OK.
FLASHING RED (once every second):
Lamp > 8,700 h (time to replace the lamp).
FLASHING RED (twice every second):
Lamp failure.
FLASHING RED (three times every second):
Ballast failure.
FLASHING RED (four times every second):
Low voltage (under 18V).*
FLASHING RED (five times every second): High voltage (over 30V).*
* Connects to a Step Down Transformer (sold separately).
How to Reset your Product and its Lamp Timer
After installing a new lamp, make sure the timer function is reset.
Step by Step Product and Lamp Timer Reset
1. On the ballast, press and hold for 3 seconds the reset button until LED
blinks. The timer has now been reset.
STEP 1
