11
Instruction Manual for SABER PRO WIRELESS 24V
1-888-726-8869
www.sanuvox.com
A. Step by Step UV Lamp Continuity Test
B. Step by Step Pairing of the LCD Wireless Display
STEP 1
STEP 2
1. Take the lamp out of the duct. First disconnect white socket from the
lamp. Then, loosen the 2 screws on the retainer ring and turn retainer
ring counterclockwise . Pull out the lamp.
2. Using an ohmmeter place 1 probe on 1 of the 4 pins and by sensing the
3 remaining pins, 1 should have continuity. Make sure the 2 remaining
pins also have continuity.
The 4 pins are in a rectangle pattern. The 2 pins that form the 2 short
sides of the rectangle are the pins that have continuity through the lamp
element.
1. Remove the LCD display cover by pressing the tab located at the
bottom of the LCD display with a flat-head screwdriver.
Separate the
cover from the housing.
2. With the LCD display cover removed,
press the black button to enter
“PAIRING” mode. Once in pairing mode, press the reset button on
the black SABER PRO WIRELESS 24V ballast.
Both the ballast and
the LCD should be within a few feet of each other.
Once the ballast and LCD display are paired, information will be
displayed on the LCD screen providing real-time system status.
STEP 2
STEP 1
