background image

1-888-726-8869 www.sanuvox.com

B

D

C

E

G

F

H

I

J

A

Sanuvox Technologies INC. All rights reserved. 2019-v.1

INSTALLATION MANUAL

WARNING

Never expose eyes or skin to ultraviolet light 

from any source. Before installing or performing 

maintenance  or  service  on  the  purifier, 

DISCONNECT from main power. Electrical 

shock can cause injury or death.

Do not touch Lamp glass without gloves. 

Reduced performance of Lamp may result. 

Clean Lamp after handling.

The UV Lamp contains a small quantity of 

mercury. If a Lamp breaks, clean and dispose 

of with care.

Use  only  specified  replacement  Lamps  with 

your  Purifier.  Use  of  an  incorrect  Lamp  can 

result in damage to the Purifier and/or Lamp 

therefor voids warranty.

A.  Holes for 1 x pair of 8" inlet collars

B.  Holes for 1 x pair of 8" outlet collars

C. 4 x 31.5" UV ‘J’ lamps

D. Aluminum reflecting chamber

E.  4 x ballast

F. Door

G. 2 x 1" pre-filter

H. Main filter (MERV 14 or opt. HEPA)

I.  Safety cut-off switch

J.  Power 120 Volt or 230 Volt

SAFETY PRECAUTIONS

When servicing UV purification-filtration equipment, observe precautions in the literature, tags and labels attached to the 

unit, and other safety measures that may apply. Follow all safety codes. Wear safety glasses and work gloves.

GENERAL

The SANUVAIR

®

 S1000 is a combination Ultraviolet - Filter Air Purification System. The SANUVAIR

®

 S1000 UV 

Germicidal Photo-Oxidation process (UVC/UVV) destroys bio-chemical contaminants such as mold, viruses, bacteria, 

germs, chemicals, cigarette smoke, VOC’s and odors. The SANUVAIR

®

 S1000 is also equipped with two 1” pre-filters and 

a MERV 14 (95%) efficiency filter. 99.97% HEPA Filter available. Details below.

OPTIONS

Depending on the model ordered, there may be additional options available.

SUBKITCROS1000

Clean Room Option. Incl. (1) HEPA 99.97% Filter (1) 

BST120W5 or (1) BST230W5 Secondary ballast (1) secondary 

LMPRGJ160 31.5” UVC ‘J’ Lamp

MSCFTR12

An optional 99.97% efficient HEPA filter (20" x 20" x 4")

SUBKITVOCS1000

VOC Kit incl. (1) VOC Sensor (1) BST120W5 or (1) BST230W5 

secondary ballast (1) secondary LMPHXJ160 UVV ‘J’ lamp. 

MSCTR12-1

An optional 99.97% efficient HEPA filter (20” x 20” x 5”) 

biological contaminants.

Summary of Contents for SANUVAIR S1000

Page 1: ... 1 INSTALLATION MANUAL SANUVAIR S1000 AIR PURIFICATION SYSTEM WITH 95 ASHRAE FILTER PLEASE SAVE FOR YOUR RECORDS DATE INSTALLED __________________________ INSTALLER CONTACT INFO ________________________________________________________________ INSTALLED BY ____________________________ ...

Page 2: ...r 230 Volt SAFETY PRECAUTIONS When servicing UV purification filtration equipment observe precautions in the literature tags and labels attached to the unit and other safety measures that may apply Follow all safety codes Wear safety glasses and work gloves GENERAL The SANUVAIR S1000 is a combination Ultraviolet Filter Air Purification System The SANUVAIR S1000 UV Germicidal Photo Oxidation proces...

Page 3: ...sed up against the right side of the SANUVAIR S1000 STEP 2 Installation of the UV Lamp The UV Lamp is to be installed in the Aluminum Reflecting Chamber To slide out the Aluminum Chamber remove the two butterfly bolts and screws which secure it in place A clamp or two if you ordered an optional second lamp is there to hold the lamp s MAKE SURE TO PUT THE RIGHT LAMP IN THE RIGHT CLAMP see label ide...

Page 4: ...1 filter MSCFTR12 1 20 x20 x5 HEPA 99 97 filter optional MSCMTR9 Motor assembly for 120V Must be ordered with MSCCAP4 Capacitor MSCCAP4 Capacitor for motor 120V MSCMTR10 Motor assembly for 230V Must be ordered with MSCCAP5 Capacitor MSCCAP5 Capacitor for motor 230V MAINTENANCE Visual inspection of the filter media should be performed and replaced as needed The 1 pre filters are designed to be an i...

Reviews: