5
Instruction Manual for SANUVAIR
®
S100
1-
778-877-3454
www.
blueg
old
labs
.com
8.
Now, prepare location for installation:
Cut a 24" x 14" opening in a
suspended ceiling tile
to install the unit. In order to facilitate the work,
remove 14" lengthwise.
9. Connect the power supply to the adapter, and the adapter to the unit.
NOTE:
Once connected, the unit will turn on automatically. Continue
with the installation while the unit is running.
STEP 8
STEP 9
STEP 10
STEP 11
10. Make sure to position the unit so that the air outlet (open end) is at least
24" from the wall.
Pass the unit through the ceiling (tilt it slightly to the side) and gently
lean the device support anchors against the tile and the ceiling support.
11. Replace the cut part of the suspended ceiling tile to hide the opening.
Then, right up against the unit, install a 24" ‘T’ bracket.
Your new SANUVAIR
®
S100 is now ready to
operate so you can enjoy great air quality
for you and your colleagues.
6. Install Filter:
While the unit cover is still open, pull on the non-mesh
end to gain access to the filter location (mesh door). Take the filter out
of its packaging and install it in the unit. Close the mesh door properly.
7. Adjust the fan speed: While the unit cover is still open, you will have
access to the speed controller. For best results, choose “Hi” and for
quieter use, choose “Low”.
Once the lamp and filter are installed and the fan settings are adjusted
to your liking, make sure to
close the unit cover properly.
STEP 7
STEP 6