Page 39
SETUP MEnU
Choosing the Modulation Type, Continued....
3) To choose the displayed Modulation Type, press and hold both the +/INC and DEC/- keys at
the same time for approximately 1 second. The transmitter will beep and the Modulation Type
displayed will stop flashing.
WARNING
Do not attempt to change the Modulation Type when your model’s receiver is turned ON under actual operational
conditions. The transmitter will lose communication with the receiver and loss of control will result.
The Binding function allows you to 'Bind' the transmitter and receiver pair. When new, it is necessary to
pair the transmitter and receiver to prevent interference from transmitters operated by other users. This
operation is referred to as 'Binding'. Once the Binding process is complete, the setting is remembered even
when the transmitter and receiver are turned OFF. Therefore, this procedure usually only needs to be done
once. Under some circumstances, the receiver may not operate after turning the transmitter and receiver
ON. If this occurs, perform the Binding process again.
BinD - BinDing
2) While holding down the Bind Button on the receiver, turn the receiver
ON. The Bind LED on the receiver will flash slowly. After approximately
2 seconds, release the Bind Button. The Bind LED on the receiver
will continue to flash slowly.
Use the tip of a pencil or a 1.5mm hex wrench to reach the Bind Button on the receiver.
Transmitter and Receiver Binding
1) Press the Right or Left MENU key to highlight the EPA menu. BIND will be displayed in the
Programming Window.
3) Press the +/INC key on the transmitter. PUSH INC will flash in the Programming
Window.
After releasing the Bind Button, you must press the +/INC key quickly (within a couple
of seconds). If you take too much time, you may need to restart the Binding process.
SETuP
+
Before beginning the Binding procedure, connect your servos and battery to the receiver, using the diagram on page 10.
Make sure that the receiver is turned OFF and that the transmitter is turned ON and in the SETUP menu.
The Gemini X 2.4GHz FHSS-3 radio control system uses FHSS-3 technology, however, the transmitter is compatible with
both FHSS-3 and FHSS-2 Sanwa and Airtronics 2.4GHz surface receivers. To bind the transmitter to an FHSS-2 2.4GHz
receiver (available separately), the transmitter Modulation Type must first be changed to FH2. For more information, see page 38.
Summary of Contents for Gemini X
Page 1: ...Page 1 ...
Page 55: ...Page 55 NOTES ...
