Page 19
PROGRAMMING MENUS
[[PROgRaMMing MEnUS
01.cH-SET (cHannEL SET)
The Channel Set function allows you to make programming changes to each of the four channels without the need to enter each
Programming Menu separately. Essentially, the Channel Set function encompasses the most common programming options in
one convenient location. For example, you can make all of your desired programming changes, such as End Point Adjustment,
Exponential, Servo Speed, Fail Safe settings, etc., for each channel, all from within the same menu.
To access the various Programming Menus, turn the transmitter 'ON', then press the ENTER key (Push-Button Rotary Dial). A list
of Programming Menus will be displayed along the right side of the screen and the last Programming Menu when the transmitter
was turned 'OFF' will be highlighted. The currently highlighted Programming Menu will be displayed in the background.
The following Programming Menus are available by scrolling UP or DOWN using the Push-Button Rotary Dial:
OvERviEw
01.CH-SET
02.D/R
03.EPA
04.CURVE
05.SPEED
06.ALB
07.OFFSET
08.AUX1
09.AUX2
10.TRIM
11.REV
12.TIMER
13.LAP
14.F/S
15.LOGGER
16.SYSTEM
Channel Set
Dual Rate
End Point Adjustment
Curve
Servo Speed
Anti-Lock Braking
Throttle Offset
Auxiliary 1
Auxiliary 2
Servo Trim
Servo Reversing
Lap and Interval Timers
Lap Times
Fail Safe
Telemetry Logging
System Menu
Change Common Programming Options in One Convenient Location
Adjust Channel Dual Rates
Adjust Channel End Points
Adjust Channel Exponential or Adjustable Rate Control (ARC)
Slow Down Servo Speed in the Forward and Return to Neutral Directions
Program the Anti-Lock Braking Function
Program the Throttle Offset Position
Choose and Adjust Auxiliary 1 Channel 3 Functions and Programming
Choose and Adjust Auxiliary 2 Channel 4 Functions and Programming
Adjust Servo Trim and Servo Sub-Trim
Change the Direction that the Servos Travel
Program the Lap Timer and the Interval Timer
Displays Current, Past and Best Lap Times
Program Fail Safe Settings
View Logs of Temperature, Voltage and RPM Telemetry Data
Access the System Menu
MENU
MENU NAME
MENU DESCRIPTION
PROGRAMMING MENUS
1) From the Top Screen, press the ENTER key to open the Programming Menu list.
2) Scroll UP or DOWN to highlight the CH-SET menu, then press the ENTER key. The
CH-SET menu will be displayed and the cursor will default to [ST].
This section details how to use the Channel Set function. For information about programming each of the Programming
Menus within the CH-SET menu, refer to the specific Programming Menu sections on the pages shown in the table above.
PAGE #
PG. 19
PG. 20
PG. 22
PG. 23
PG. 25
PG. 27
PG. 28
PG. 29
PG. 36
PG. 42
PG. 44
PG. 44
PG. 47
PG. 48
PG. 49
PG. 51
3) Scroll DOWN to move the cursor to the channel you would like to make programming
value changes to. Choose from <CH-SET> [ST] (Steering), <CH-SET> [TH] (Throttle),
<CH-SET> [A1] (Auxiliary 1) or <CH-SET> [A2] (Auxiliary 2).
Summary of Contents for MT-4
Page 1: ...OPERATING MANUAL ...
