Sanwa MT-4, Operating Manual

Page 20

01.cH-SET (cHannEL SET), cOnTinUED....

6)  After changing the desired programming value, press the ENTER key or the Back/Cancel key and the highlighted option will 

stop flashing, indicating you can scroll UP or DOWN to highlight another programming option. To change to another channel, 

press the Back/Cancel key, then scroll UP or DOWN to select the desired channel. Repeat steps 4 and 5 above to change 

the desired programming values for that channel.

7)  When complete, press and HOLD the Back/Cancel key to return to the Top Screen.

4)  Press the ENTER key to highlight the programming value in the upper right corner.

5)  Scroll  UP  or  DOWN  to  highlight  the  programming  value  you  would  like  to  change, 

then press the ENTER key to select it. The highlighted programming value will flash 

indicating you can change the programming value. Scroll UP or DOWN to change the 

programming value

01.D/R - RATE
02.EPA - L/R
03.EPA - LEFT
04.EPA - RIGHT
05.CURVE - RATE
06.CURVE - POINT
07.SPEED - FORWARD
08.SPEED - RETURN
09.TRIM
10.SUB-T
11.REV - NOR/REV
12.F/S

01.D/R - TH
02.D/R - BR
03.EPA - HIGH
04.EPA - LOW
05.CURVE - RATE-H
06.CURVE - POINT-H
07.CURVE - RATE-B
08.CURVE - RATE-H
09.SPEED - FORWARD
10.SPEED - RETURN
11.ALB - POINT
12.ALB - STROKE
13.ALB - LAG
14.ALB - RELEASE
15.ALB - HOLD
16.TRIM
17.SUB-T
18.REV - NOR/REV
19.F/S

01.EPA - HIGH
02.EPA - LOW
03.CURVE - RATE
04.CURVE - POINT
05.CURVE 
06.CURVE
07.SPEED - FORWARD
08.SPEED - RETURN
09.TRIM
10.SUB-T
11.REV - NOR/REV
12.F/S

01.EPA - HIGH
02.EPA - LOW
03.CURVE - RATE
04.CURVE - POINT
05.CURVE
06.CURVE
07.SPEED - FORWARD
08.SPEED - RETURN
09.TRIM
10.SUB-T
11.REV - NOR/REV
12.F/S

[ST] STEERING

[TH] THROTTLE

[A1] AUXILIARY 1

[A1] AUXILIARY 2

The following Programming Menus are available from within the Channel Set menu:

02.D/R (DUaL RaTE)

Dual Rate is a percentage of End Point Adjustment. For example, if you set the Steering Dual Rate percentage value to 

100%, the steering will travel the same amount as defined by your End Point Adjustment programming. If you set the Steering 

Dual Rate percentage value to 50%, the steering will travel half that amount.

The Dual Rate function allows you to change the control authority of the Steering, Throttle High Side and Throttle Brake Side by 

changing the amount of servo travel relative to control input. For example, by increasing the Steering Dual Rate, you can make 

the steering servo travel more which might prevent your model from pushing during turns. If your model oversteers during turns, 

you can reduce the amount of Steering Dual Rate.

[[PROgRaMMing MEnUS

IMPORTANT:

  Prior to programming the Dual Rate function, you should adjust the maximum Left and Right (or High and 

Low) End Points, using the End Point Adjustment function. For more information, see the 

End Point Adjustment

 section on 

pages 22 and 23.