Sanwa MT-4, Operating Manual

Page 26

[[PROgRaMMing MEnUS

3)  Scroll  UP  or  DOWN  to  highlight  the  desired  channel  you  would  like  to  change  the 

Forward  Speed  value  for.  Choose  from  either  [ST]  :  FORWARD  0  (Steering), 

[TH] : FORWARD 0 (Throttle), [A1] : FORWARD 0 (Auxiliary 1) or [A2] : FORWARD 0 

(Auxiliary 2).

4)  Press the ENTER key, then scroll DOWN to decrease servo Speed in the Forward 

direction. Decreasing the Forward Speed value will cause the servo transit time to slow 

down when it moves from the Neutral position to either End Point.

SPEED FORWARD setting range is -100 to 0. The default setting is 0 (Normal Speed).

Adjusting the Return to Neutral Speed Value

1)  From within the SPEED menu, scroll UP or DOWN to highlight the desired channel you 

would like to change the Return to Neutral Speed value for. Choose from either [ST] : 

RETURN 0 (Steering), [TH] : RETURN 0 (Throttle), [A1] : RETURN 0 (Auxiliary 1) or 

[A2] : RETURN 0 (Auxiliary 2).

2)  Press the ENTER key, then scroll DOWN to decrease servo Speed in the Return to 

Neutral direction. Decreasing the Return to Neutral Speed value will cause the servo 

transit time to slow down when it moves from either End Point to the Neutral position.

SPEED RETURN setting range is -100 to 0. The default setting is 0 (Normal Speed).

Adjusting the Forward Speed Value

1)  From the Top Screen, press the ENTER key to open the Programming Menu list.

2)  Scroll UP or DOWN to highlight the SPEED menu, then press the ENTER key. The 

SPEED menu will be displayed and [ST] : FORWARD 0 will be highlighted.

05.SPEED (SERvO SPEED), cOnTinUED....

Controlling the Servo Speed Function

1)  By assigning the Steering and Throttle Forward and Return to Neutral Speed programming functions to one or more of the 

Trim Switches, Auxiliary Lever or Dial Knob, these functions can be adjusted while driving without accessing the Programming 

Menu. In addition, the Steering Speed and Throttle Speed functions can be Toggled 'OFF' and 'ON' by assigning them to one 

or more Push-Button Switches. For more information, see the 

Key Assignments

 section on pages 56 ~ 61.

Auxiliary 1 and Auxiliary 2 Forward and Return to Neutral Speed programming functions cannot be assigned.

IMPORTANT:

  Throttle Servo Speed affects only the Throttle High Side. The Throttle Brake Side is unaffected. See Throttle 

diagram on previous page.