SY16C Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 0420
4-57
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Unloading the Machine
1. Always load/unload the machine on firm, level ground
and keep a safe distance away from roads.
2. Brake the trailer properly and chock (1) the trailer
wheels. Place the ramps (2) between the trailer and the
machine. Make sure the two ramps are on the same
level and have an angle less than 15°. Adjust the
distance between the ramps to match the distance
between the tracks.
3. Remove chains or wire ropes that secure the machine.
4. Unlock the boom. See “Boom Swing Lock Handle” on
5. Start the engine. See “Starting the Engine” on page 4-
16.
6. Push the hydraulic lockout control lever to the
unlocked (open) position.
7. Raise the work equipment and retract the arm toward
the boom. Drive the machine slowly.
8. Stop the machine when it travels over the rear wheels
of the trailer and toward the ramps.
NOTICE!
Use extreme care when the machine drives over the joint area between the trailer and the
ramps.
Prevent damage caused by unexpected movement of the work equipment. Maintain the
boom-arm angle between 90° and 110°. Unloading the machine with the arm retracted may
damage the machine.
Fig. 4-82
0002935
2
1
0002947
Fig. 4-83
Summary of Contents for SY16C
Page 2: ...Page Intentionally Blank ...
Page 207: ...Page Intentionally Blank ...
