SY16C Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 0420
4-21
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
6. Manage engine power to allow acceleration to governed speed when conditions require more power. Do not
over-rev the engine.
7. Always allow the engine to cool before shutting it off.
8. After shutting off the engine, check the fluid levels.
Engine Shutdown
1. Park the machine on a firm, level surface.
2. Lower the bucket or optional equipment to the ground.
3. Push the throttle control lever (1) forward (low idle)
and allow the engine to idle for 5 minutes to cool
down.
4. Turn the key switch (2) to OFF and remove the key.
Pull the hydraulic lockout control lever (3) back to the
locked (closed) position.
NOTICE!
• Stopping the engine before it cools can
accelerate engine component wear. Never
abruptly shut down the engine except in an
emergency.
• Never stop the engine suddenly when it is
overheated. Run the engine at low idle to
allow it to cool down gradually before
shutting it down.
Failure to follow this notice could result in
damage to the machine or cause it to operate
improperly.
Fig. 4-18
0005095
2
1
Fig. 4-19
0005094
3
Summary of Contents for SY16C
Page 2: ...Page Intentionally Blank ...
Page 207: ...Page Intentionally Blank ...
