SY265C LC/SY265C LR Excavator OMM
SANY
Operation and Maintenance Manual — 0420
4-49
TA
BLE OF
CO
NTENTS
INTRODUCTION
SA
FE
T
Y
MA
CHINE
CONTROLS
MA
CHINE
OPERA
T
ION
MAINTEN
ANCE
SPECI
FICA
TIONS
OPTIONAL
EQUIP
M
ENT
5. Install new bucket teeth (4) and roll pins (5) in the
reverse order of removal.
Replace the Bucket
Remove the Bucket
1. Prepare the machine for service. See “Maintenance
2. Lower the bucket to the ground and support the bucket
to prevent it from rolling over when the bucket pin is
removed.
3. Remove the bucket pin hardware and bucket pins (2)
and (4) and remove the bucket (3) from the arm (1) and
linkage (5).
4. Clean the pins and pin bores. Lubricate the pin bores
with grease.
CAUTION!
• Keep fingers and other body parts away from pinch points to prevent crushing injuries
while removing or installing the bucket. Never put your finger into the pin bore during
alignment
• Secure bucket after removal and before servicing.
• Bucket pins may be ejected with force when removed forcefully. Do not allow anyone to
stand in front of the pins during removal.
• Never stand or place your feet or other body part under the bucket when removing bucket
pins.
Failure to follow these precautions could result in death or serious injury.
Fig. 4-69
0002352
5
4
Fig. 4-70
2
4
3
1
5
0004799
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
