SY265C LC/SY265C LR Excavator OMM
SANY
Operation and Maintenance Manual — 0420
5-21
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
3. Check the engine coolant level in the sight glass (2) on
the side of the expansion tank. The acceptable engine
coolant level is the middle of the sight glass.
Fill the Engine Coolant
1. Prepare the machine for service. See “Maintenance
2. Open the engine compartment door. See “Engine
Compartment Door” on page 4-11.
3. Slowly loosen the expansion tank cap (1) to relieve any
engine cooling system pressure.
4. Remove the expansion tank cap when engine cooling
system pressure has been relieved.
5. For engine coolant capacity, see “Capacities” on
6. Add new engine coolant through the expansion tank
until the engine coolant level reaches the middle of the sight glass (2).
7. Install the expansion tank cap.
8. Start the engine and run it at low idle for several minutes to allow engine coolant to circulate.
WARNING!
• Engine coolant is toxic. Avoid inhaling or ingesting engine coolant. If eyes or skin are
contaminated by coolant, wash the affected area with plenty of water and seek medical
treatment immediately.
• Do not remove the radiator cap while the engine is hot. Engine coolant is under pressure
when the engine is hot. Avoid contact with hot engine coolant. Allow the engine to cool
before removing the radiator cap.
Failure to follow these warnings could result in death or serious injury.
Fig. 5-2
0005184
2
Fig. 5-3
1
2
0005184
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...
