SY35U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 0120
4-17
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
NOTE:
The illustration shows a cab machine. Canopy machines are similar.
6. Turn the throttle control dial (2) to MIN (low idle).
7. Insert the key into the key switch (3).
8. Turn the key switch to ON (do not start the engine) and
check the following items on the monitor display:
•
Engine coolant temperature
•
Fuel level
•
Fault codes
NOTE:
If all readings are normal and no fault codes
are present, the monitor display returns to the
home screen within 2 seconds after the key
switch is turned to ON.
10. Turn the key switch to START, and the starter motor will crank the engine. Release the key after the engine has
started, and the key switch will return to ON.
NOTICE!
Before starting the engine, make sure that the throttle control dial is at MIN (low idle). Starting
the engine with the throttle control dial at MAX (high idle) will accelerate the engine and could
cause damage.
NOTICE!
•
Never crank the engine for more than 15 seconds.
•
If the engine fails to start after 15 seconds, stop and allow the starter motor to cool for at
least 2 minutes before attempting another start.
•
If the engine fails to start after five attempts, contact a SANY dealer.
Failure to follow this notice could damage the machine or cause it to operate improperly.
Fig. 4-17
0002782
2
3
