SY35U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 0120
4-51
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
TRANSPORTATION INFORMATION
Transportation Method
Applicable laws and regulations must be observed when transporting the machine:
•
When transporting the machine with a trailer, confirm the length, width, height, and weight capacity of the
trailer before loading.
•
Investigate the road conditions in advance (for example, dimension restrictions, weight restrictions, and
traffic regulations).
•
The machine may need to be disassembled to meet the local dimension and/or weight limits.
NOTE:
The machine’s shipping weight and dimensions may vary, depending on its tracks and work
equipment.
Loading and Unloading
WARNING!
•
To prevent the machine from tipping over, select a firm and level location that is a safe
distance from any road or structure.
•
Make sure the trailer is properly chocked to prevent any movement.
•
Use an access ramp with enough length, strength, and width to properly support the
machine. The ramp grade should not exceed 15°.
•
Drive slowly at the junction of the ramp and the trailer. The machine may shift suddenly due
to a change in its center of gravity.
•
Use a signalman to alert the operator to any potential hazards.
•
Deactivate the auto idle mode before loading or unloading; otherwise, the machine may
move suddenly.
•
Adjust the throttle control lever to MIN (low idle). Operating the engine at high speed could
result in sudden, unexpected movement.
•
Swinging the upper structure may cause the machine to tip over and result in personal
injury. Retract and lower the arm and swing the upper structure slowly to achieve the
optimal balance.
•
Grease, mud, or ice on the trailer, landing platform, and ramps can cause the machine to
slide and tip over.
Failure to follow these warnings could result in death or serious injury.
