SY35U Excavator OMM
Safety
SANY
Operation and Maintenance Manual — 0120
2-5
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
Mount and Dismount the Machine
Fig. 2-1
0003054
Mounting or dismounting the machine presents hazards.
Observe the following:
•
Always make sure the hydraulic lockout control
lever is in the locked (closed) position before
entering or exiting the machine.
•
Always make sure the machine is at a complete
stop, work equipment is lowered to the ground, and
the engine is shut down, before entering or exiting
the machine. Never jump on or off the machine.
•
Never exit or enter the machine by any means
other than the provided grab handles and steps.
•
Always face the machine as you mount and dismount.
•
Always maintain three-point contact (both feet and one hand, or one foot and both hands) with the grab
handles, steps, and deck for proper support.
•
Wear safety shoes with slip-resistant soles.
•
Do not walk on any surface of the machine if its slip-resistant material is missing or excessively worn. Do
not step on surfaces of the machine that are not approved for walking or working. Keep all walking and
working surfaces of the machine clean, dry, and slip-resistant.
•
Always keep grab handles, steps, and walkway areas clean and clear of mud, oil, grease, or similar debris.
If these areas are damaged, have them repaired or replaced immediately.
MACHINE SAFETY
Authorized Use of This Machine
This cab or canopy excavator is a multipurpose construction machine used primarily for digging or loading earth
and stones. It can also be used for grading, slope-trimming, lifting, breaking, demolishing, and trenching. It can
perform the functions of bulldozer, loader, and crane.
This excavator can also operated a variety of optional equipment.
SANY assumes no responsibility for any consequence caused by use outside this specified range.
Unauthorized Use of This Machine
Unauthorized uses include, but are not limited to, the following:
•
Transporting riders on the machine or in the cab.
•
Towing or pushing other equipment.
