Machine Controls
SY35U Excavator OMM
3-24
Operation and Maintenance Manual — 0120
SANY
3. Inside the cab, grasp left and right grips (3) and press
down the latches (2) with your thumbs. Pull grips back
slightly and lift the windshield to disengage the latches,
then move the windshield up to the roof of the cab until
it locks.
NOTE:
The right side is shown. The left side is
similar.
Closing the Windshield
1. Before closing the windshield, park the machine on
level ground, lower the work equipment to the ground,
and stop the engine.
2. Move the hydraulic lockout control lever (1) to the
locked (closed) position.
CAUTION!
When open, the windshield must be secured to
the roof of the cab. If it is not secured, the
windshield may slide down unexpectedly and
result in injury or machine damage.
CAUTION!
Close the windshield slowly to avoid pinching
hands or fingers. Failure to follow this caution
could result in injury.
Fig. 3-38
0002986
2
3
Fig. 3-39
1
0002781
