SY35U Excavator OMM
Machine Controls
SANY
Operation and Maintenance Manual — 0120
3-25
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
3. Grasp left and right grips (3) and press down the
latches (2) with your thumbs. Move the windshield
forward and down, and release the latches.
NOTE:
The right side is shown; the left side is
similar.
4. When the front windshield reaches the lowered
position, firmly push the left and right grips forward at
the top of the front windshield to engage the latches.
Lower Front Windshield
1. Raise the windshield to remove the lower front
windshield (1). See “Opening the Windshield” on
page
NOTE:
Sand or dust accumulated along the bottom of
the lower front windshield and the seal may
make it difficult to remove or install. Make
sure the bottom of the lower front windshield
and the seal are clean before removing or
installing it.
2. Rotate the latches (2) to clear the lower front
windshield.
3. Firmly grasp the lower front windshield knobs (3) and lift upward for removal.
4. Installation is done in the reverse order of removal. Make sure the bottom of the lower front windshield is
seated in the seal.
Fig. 3-40
0002987
3
2
0003236
Fig. 3-41
2
2
3
1
3
