Maintenance
SY35U Excavator OMM
5-32
Operation and Maintenance Manual — 0120
SANY
Check the Engine Oil Level
1. Prepare the machine for service. See “Maintenance
2. Open the engine hood.
3. Remove the dipstick (1) and wipe off the engine oil
with a clean cloth.
4. Fully insert the dipstick into the dipstick opening, then
remove it and note the oil level on the dipstick.
5. The engine oil level must be maintained between the
upper mark (2) and lower mark (3) of the dipstick. Add
clean engine oil until the oil level is at the upper mark of
the dipstick.
6. Add engine oil through the filler port (4) as required.
Always use SANY-recommended engine oil.
NOTE:
If the oil level is above the upper mark on the
dipstick, drain the excess oil. See “Change the
Engine Oil and Filter” on page
WARNING!
Hot oil and engine components may cause burns or other serious injury. Allow the engine to
cool before performing engine maintenance. Failure to follow this warning could result in
death or serious injury.
NOTICE!
Do not add oil past the upper mark on the
dipstick, as this may result in engine damage.
Fig. 5-23
0003773
1
Fig. 5-24
0002770
2
3
Fig. 5-25
0002771
4
