SANY SY500H Operation And Maintenance Manual Download

Page: 24 / 196

2-2

SAFETY

SY500H Excavator OMM

General Safety

This section provides detailed information on basic safety
precautions and preventive measures that should be
followed during the operation and maintenance of this
machine.

Hazard Alerts in This Manual

Hazard alerts in this manual are used to alert operators,
job supervisors, maintenance staff, and job site workers
to hazardous operating practices and maintenance
procedures. Hazard alerts are used throughout this
manual. Each hazard alert contains a hazard-alert
symbol and a signal word to identify the hazard’s degree
of consequence if the message is ignored.
The following American National Standards Institute
(ANSI) and International Organization for Standardization
(ISO) signal words are used to warn of potentially
hazardous situations that may lead to damage, personal
injury, or even death. In this manual and on the machine
decals, different signal words or illustrations are used to
express the potential level of hazard.

DANGER

DANGER indicates a hazardous situation which, if
not avoided, will result in death or serious injury.

WARNING

WARNING indicates a hazardous situation which,
if not avoided, could result in death or serious
injury.

CAUTION

CAUTION indicates a hazardous situation which,
if not avoided, could result in injury.

NOTICE!

NOTICE is used to address practices not related
to personal injury.

This symbol is used within a graphic to alert the
user not to do something.

Operator Safety Information

It is impossible to compile a list of safety precautions that
covers every situation. However, there are basic
principles that must be followed when operating this
machine:

• Only qualified personnel who have been specifically

trained on this machine are permitted to operate
and/or work on this machine.

• The seat belt must be worn by the operator at all

times.

• Operator aids such as warning lights, horns, or

buzzers, along with displays on the monitors, are
designed to alert the operator to potential problems.
Sole reliance on these operator aids in place of good

operating practices can lead to an accident. Inspect
the operator aids of this machine daily and make
sure each operator aid is in normal working
condition. Any faults found shall be reported to a
SANY dealer. Stop all work immediately if any
operator aid is not working properly.

• All accident prevention guidelines, operating

instructions, etc., are based on the intended usage

of the machine.

• Read and understand this manual and any

accompanying manuals before operating this
machine.

• This manual must be readily available to the

operator at all times and must remain in the cab
while the machine is in use.

• Make sure all personnel in the working area around

the machine are thoroughly familiar with the safe
operating practices stated in this manual.

• Review the local, state, and federal regulations and

standards regarding this machine and its operation.
Work practice requirements may vary among
government regulations, industry standards, and
employer policies. A thorough knowledge of all such

relevant work rules is required before operating this
machine or performing maintenance on it.

• Check the maintenance log before the start of each

workday shift. Make sure routine maintenance has
been performed as stated in this manual. Do not
operate a damaged or improperly maintained
machine.

• Only the operator is to be on the machine while it is

in operation.

• Be sure all underground utilities have been marked

before excavating.