SY50U Excavator OMM
Machine Controls
SANY
Operation and Maintenance Manual — 0120
3-13
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
Maintain Table Screen
Displays when the machine is due for maintenance. If maintenance is not due, the Maintain Table screen will not
open.
The Maintain Table screen is also used to reset the service timer.
Operating Mode Screen
Fig. 3-15
0003816
12
11
9
10
1
4
6
7
2
3
5
8
The Operating Mode screen is used to select a work tool or
the equivalent one-way or two-way flow required.
The Operating Mode screen displays the bucket (1) as the
default operation. The auxiliary ports are used for
hydraulic work tools. Select the proper work tool icon prior
to operating it:
•
Bucket (default) (1)
•
Breaker (2)
•
Clamshell bucket (3)
•
Tilt bucket (4)
•
Auger (5)
•
Rotary grapple (6)
•
Grapple (7)
•
Brush cutter (8)
NOTE:
Check the work tool operator manual or contact a SANY dealer for hydraulic flow rate information.
•
Press the button below the left/right arrow icon (9) to scroll to and illuminate the selected work tool icon.
•
Press the button below the information icon (10) to access the Flow Rate Information screen. Flow rate for
a work tool can be adjusted on this page. See “Flow Rate Information Screen” on page
•
Press the button below the check-mark icon (11) to confirm the selected work tool function.
•
Press the button below the return icon (12) to return to the previous screen.
