Machine Controls
SY50U Excavator OMM
3-4
Operation and Maintenance Manual — 0120
SANY
MONITOR
The monitor displays machine operating information and provides access to change system parameters.
Daily Maintenance Information Screen
Fig. 3-2
0003808
1
When the key switch is turned to ON, the monitor displays
the Daily Maintenance Information screen.
The screen lists 7 steps that need to be confirmed complete
before starting the machine. See “Prestart Checks and
Adjustments” on page 4-5.
The eighth step reminds to warm up the engine and
hydraulic system before normal operation of the machine.
See “Prestart Checks and Adjustments” on page
Start the machine and idle until its operating temperature is
reached. See “Starting the Engine” on page
Press the button below the check-mark icon (1) to confirm
all checks and procedures have been completed. The
display will change to the home screen.
NOTE:
If maintenance is required, the Maintenance
Information screen will display instead of the
Daily Maintenance screen. See “Maintenance
Information Screen” on page
